CS2,62 mm Silikon-O-Ring ID37,77/39,34/40,94/42,52 x 2,62 mm 50 Stück O-Ring VMQ Dichtungsdichtung Dicke 2,62 mm ORing Weiß Rot Gummi

Produktbeschreibung

O-ring Sealing Principles
O-rings are bi-directional seals, circular in shape and cross section. O-rings are generally
made of an elastomeric material, but may be made of other materials such as PTFE or
metal. An O-ring seals through the deformation of the seal material by installation and media pressure to close off the gap between mating components. Higher system pressures can cause deformation through the gap, known as extrusion, resulting in seal failure. Choosing a harder seal material or installing back-up rings to support the O-ring may alleviate this problem.
Method of operation
O-Rings are double-acting sealingelements. The inital squeeze,which acts in aradialora xial direction depending on the installation, gives the O-Ring its initial sealing capability.These forces are superimposed by the system pressure to create the total sealing force which increases as the systeme pressure increases (Figure 2).
Under pressure, the O-Ring behaves in asimilar way to a fluid with high surface tension. The pressure is transmitted uniformly to all directions.
VMQ (Silicone Ring)
It has good electrical insulation properties. Tensile strength is worse than the general rubber and not oil-resistant, silicone temperature-resistant range temperature:-43~210℃, the most outstanding advantage is that it has excellent high temperature resistance, anti-static properties.
Application
The O-Ring is used predominantly for static sealing applications
As aradial static seal, e.g. for bushings, covers, pipes, cylinders
As an axial static seal, e.g. for flanges, plates, caps.
O-Rings in dynamic applications are recommended only for moderate service conditions.They are limited by the speed and the pressure against which they are to seal
Forlow duty sealing of reciprocatingpistons, rods, plungers, etc.
For sealing of slowlypivoting,r otating or spiral movements on shafts, spindles,rotary transmission leadthroughs, etc.

Produktdetails in Bildern

Produkteigenschaften

Markenname

FUSHI

Ursprung

CN (Herkunft)

Material

Silizium

Hochbetriebenes Chemikalienunternehmen

Keine

Modellnummer

Thickness 2.62X37.77/39.34/40.94/42.52/44.12/45.69mm

Form

Ringdichtung

Standard oder Nichtstandard

Standard

Zertifizierung

RoHS-Konformität